LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 667 (Electronic Control Modules (Service Information) 2500 Hd & 3500 Hd) >> Module, A/C And Heater >> Installation >> Installation

Module, A/C And Heater: Installation: Installation

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wire harness connector to the A/C heater module.
  2. Position the A/C heater module to the instrument panel, through the glove box opening and engage the module retaining screws to the slots on instrument panel.
    Fig 1: Two Screws & A/C Heater Module
    GC0154539Courtesy of CHRYSLER GROUP, LLC
  3. Tighten the two screws (1) that secure the A/C heater module (2) to the instrument panel to 2 N.m (17 in. lbs.).
  4. Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  5. Install the right side instrument panel end cap.
  6. Connect the negative battery cable.
  7. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals