Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

DTC IS ACTIVE
NOTE:
Diagnose all CAN B and C communication DTCs before continuing.
1. Ignition on, engine not running.
2. With the scan tool, read DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go To 2.
  No
  - Go To 3.
CHECK FOR SAS DTCS
1. With the scan tool, read DTCs in the Anti-lock Brake System (ABS) Module.
  Are there any SAS DTCs present?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to DIAGNOSIS AND TESTING .
  No
  - Replace the Drive Train Control Module (DTCM) in accordance with the Service Information.
  - Perform DTCM VERIFICATION TEST. Refer to DTCM VERIFICATION TEST .
INTERMITTENT WIRING HARNESS AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
3. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
4. Look for the data to change or for the DTC to reset during the wiggle test.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform DTCM VERIFICATION TEST. Refer to DTCM VERIFICATION TEST .
  No
  - Test complete.