LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 659 (Audio/Video/Entertainment/Connectivity (Service Information) 2500 Hd & 3500 Hd) >> Mast, Antenna >> Removal >> Removal

Mast, Antenna: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cowl Trim Panel
GC0089061Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel (1). Refer to PANEL, COWL TRIM, REMOVAL .
    Fig 2: Instrument Panel Antenna Connector And Antenna Mast Connector
    GC0143941Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the antenna mast connector (2) from the instrument panel antenna connector (1).
    Fig 3: Removing Antenna Mast
    GC0143942Courtesy of CHRYSLER GROUP, LLC
  4. Securely tie a suitable length of cord or twine to the antenna half of the coaxial cable connector. This cord will be used to pull the cable back into position during installation.
  5. Remove the antenna mast (1).
    Fig 4: Removing Grommet & Antenna Cap Nut
    GC0143943Courtesy of CHRYSLER GROUP, LLC
  6. Remove the antenna cap nut (1) using the (special tool #C-4816, Socket, Antenna).
  7. Remove the antenna adapter (4).
  8. With the passenger door open, pull the antenna body assembly out through the opening between the fender and body.
scientia non olet · About LEMON Manuals