Section 658 (Charging (Service Information) 2500 Hd & 3500 Hd): Generator: Removal: 6.4L
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disconnect the negative cable from the battery before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage to the electrical system.
- Disconnect and isolate the negative battery cable.
- Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
- Unsnap the plastic insulator cap (5) from the B+ output terminal.
- Remove the B+ terminal mounting nut (2) at the rear of the generator. Disconnect the terminal from the generator.
- Disconnect the field wire connector (6) at the rear of the generator by pushing on the connector tab.
- Remove the mounting bolts (3).
- Remove the generator (1) from vehicle.