System, Closed Crankcase Ventilation (CCV): Installation: Installation

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cylinder Head Cover & Gasket

Courtesy of CHRYSLER GROUP, LLC

Clean the filter sealing surface on the cylinder head cover (2) with a clean shop towel.
Install a new gasket (1) onto the cylinder head cover (2).

Fig 2: Bottom O-Rings & Breather Element
Courtesy of CHRYSLER GROUP, LLC
Apply clean engine oil to the two bottom O-ring (1) on the breather element (2) and install the new breather element onto the cylinder head cover.

Fig 3: Top O-Ring
Courtesy of CHRYSLER GROUP, LLC
Apply clean engine oil to the top O-ring (1) on the breather element (2).

Fig 4: Breather Element & Cylinder Head Cover
Courtesy of CHRYSLER GROUP, LLC
Install the breather element (1) onto the cylinder head cover (2).

Fig 5: CCV Cover & Bolts
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
The use of air tools is not recommended as damage to the component may result.
Install the breather cover (2) and the oil fill cap. Tighten bolts (1) to 10 N.m (89 in. lbs.).

Fig 6: Crankcase Pressure Sensor Wire Harness Connector & Clamp
Courtesy of CHRYSLER GROUP, LLC
Install the breather hose (2) onto the breather cover.
Connect the crankcase pressure sensor wire harness connector (1).

Fig 7: Engine Cover, Bolts & Oil Dipstick
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (3). Tighten bolts (1) to 10 N.m (89 in. lbs.).
Install the engine oil dipstick (2).
Connect both negative battery cables.