Rocker Arm, Valve: Removal: Removal
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ROCKER ARM |
| 2 - PEDESTAL |
- Disconnect both negative battery cables.
- Remove cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL, 6.7L .
- Remove the rocker arm/pedestal fasteners and remove rocker arm (1) and pedestal (2) from cylinder head. Mark the arms and pedestals so they can be installed in their original position.CAUTION:
When removing the rocker arms, the sockets may come loose and fall into the engine. Make sure they stay with the arm upon removal/installation.
- Lift the push rod(s) up and out of the engine. Mark them so they can be installed in their original position.NOTE:
The No. 5 cylinder intake and exhaust, and No. 6 cylinder intake and exhaust push rods must be raised through the provided cowl panel access holes.
- Lift the crossheads off of the valve stems. Mark them so they can be installed in their original position.