Pump, Water: Removal: 6.4L

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Manifold Removal/Installation Sequence

Courtesy of CHRYSLER GROUP, LLC

Disconnect negative battery cable.
Remove the intake assembly. Refer to MANIFOLD, INTAKE, REMOVAL, 6.4L GAS .
Remove the mechanical cooling fan assembly. Refer to FAN, COOLING, ELECTRIC, REMOVAL and/or FAN, COOLING, VISCOUS, REMOVAL .
Drain coolant into a clean container. Refer to STANDARD PROCEDURE .

Fig 2: Upper Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Remove the upper radiator hose (4) from the thermostat housing (1) and position aside.
If equipped, remove the secondary generator. Refer to GENERATOR, REMOVAL .
Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .

Fig 3: Lower Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Separate the hose (3) from the lower bypass tube.
Remove lower radiator hose (2) from the water pump and position aside.

Fig 4: Bolt, EGR Cooler Hose & Bypass Tube
Courtesy of CHRYSLER GROUP, LLC
Remove the EGR cooler hose (2) at the bypass tube (3).
Remove the bolt (1) for the upper bypass tube from the timing cover.

Fig 5: Supply Line Bracket Nut, Temperature Sensor Electrical Connector & Supply Line
Courtesy of CHRYSLER GROUP, LLC
Remove the supply line (3).
Disconnect the temperature sensor electrical connector (2).
Remove the supply line bracket nut (1).

Fig 6: Water Pump Removal & Installation Sequence
Courtesy of CHRYSLER GROUP, LLC
Remove belt tensioner assembly (1) to gain access to the water pump bolt (14). Refer to TENSIONER, BELT, REMOVAL .
Remove water pump mounting bolts and remove pump from the timing cover.