TENSIONER, Belt: Installation: 6.4L
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing accessory drive belt onto pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulleys.
- Position the belt tensioner assembly (7) onto the front of the engine block. Tighten the bolt to 55 N.m (41 ft. lbs.).
- Install the accessory drive belt (4). Refer to BELT, SERPENTINE, INSTALLATION .