Belt, Serpentine: Installation: 6.4L
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing accessory drive belt onto pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulleys.
- Position the accessory drive belt (4) over all pulleys (1, 2, 3, 5, 6) except for the water pump pulley (8).
- Rotate the tensioner (7) clockwise
and slip the belt over the water pump pulley (8).CAUTION:
Do not let the tensioner arm snap back to the freearm position, severe damage may occur to the tensioner.
- Gently release the tensioner (7).
- If removed, install the secondary belt (3).