Reset Oil Change Indicator
WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
After performing the needed maintenance, reset the
Oil Change Required
indicator using the following procedure:
NOTE:
Use the steering wheel EVIC controls for the following procedure(s).
Vehicles Equipped With Passive Entry
- Without pressing the brake pedal, press the ENGINE START/STOP button and cycle the ignition to the ON/RUN position (do not start the engine.)
- Press and release the DOWN arrow button to scroll downward through the main menu to "Vehicle Info".
- Press and release the RIGHT arrow button to access the "Oil Life" screen.
- Press and hold the RIGHT arrow button for one second to access the "Oil Life Reset" screen.
- Press and release the DOWN arrow button to select "Yes", then press and release the Right arrow button to select reset of the Oil Life.
- Press and release the UP arrow button to exit the EVIC screen.
Vehicles Not Equipped With Passive Entry
- Without pressing the brake pedal, cycle the ignition to the ON/RUN position (do not start the engine.)
- Press and release the DOWN arrow button to scroll downward through the main menu to " Vehicle Info ".
- Press and release the RIGHT arrow button to access the " Oil Life " screen.
- Press and hold the RIGHT arrow button for one second to access the " Oil Life Reset " screen.
- Press and release the DOWN arrow button to select "Yes", then press and release the Right arrow button to select reset of the Oil Life.
- Press and release the UP arrow button to exit the EVIC screen.
NOTE:
If the Oil Change Required indicator message illuminates when you start the engine, the indicator did not reset. If necessary, repeat this procedure.