LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 644 (Heating & Air Conditioning (Service Information) 2500 Hd & 3500 Hd) >> Plumbing >> Line, A/C Discharge >> Removal >> 6.7L Diesel Engine

6.7L Diesel Engine

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

Fig 1: Identifying A/C Pressure Transducer & Discharge Line
GC0137177Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air filter housing.
  4. Disconnect the wire harness connector from the A/C pressure transducer (1).
  5. Remove the nut (3) that secures the A/C discharge line (2) to the condenser jumper line tapping block (4).
  6. Disconnect the A/C discharge line from the condenser jumper line tapping block and remove and discard the O-ring seal and gasket.
    Fig 2: Nuts, A/C Compressor, A/C Suction Line & A/C Discharge Line
    GC0137128Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Illustration shown with lower radiator hose removed for clarity.

  7. Remove the turbocharger outlet tube.
  8. Remove the nut (1) that secures the A/C discharge line (4) to the A/C compressor (2).
  9. Disconnect the A/C discharge line from the A/C compressor and remove and discard the O-ring seal and gasket.
  10. Install plugs in, or tape over the opened discharge line fittings and the compressor and jumper line ports.
  11. If necessary, remove the A/C pressure transducer from the A/C discharge line. Refer to TRANSDUCER, A/C PRESSURE, REMOVAL .
scientia non olet · About LEMON Manuals