Motor, Adjustable Pedals: Removal: Removal

WARNING: This page is about a different car, the 2014 RAM 3500 HD and 2014 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If equipped with adjustable pedals: When replacing the components both pedal assemblies must be in the fully down position toward the floor for proper adjustment. Pedals can be moved manually by rotating the cable on the component not being replaced. New components come in the correct position until activated.

Remove the pedal assembly, Refer to PEDAL(S), BRAKE AND/OR ACCELERATOR, REMOVAL .

Fig 1: Adjustable Pedals System Components
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The adjustable pedal motor has three locking tabs (3) that prevent easy twisting when removing drive cable from housing.
Disconnect the drive cable (2) from the adjustable pedal motor (5) by twisting clockwise and lifting from motor.

Fig 2: Locating Accelerator Sub-Assembly Bracket Mounting Nut
Courtesy of CHRYSLER GROUP, LLC
Remove the accelerator subassembly bracket mounting nut (3).

Fig 3: Adjustable Pedals System Components
Courtesy of CHRYSLER GROUP, LLC
Remove the accelerator subassembly mounting screw (4).
Remove the accelerator subassembly (6).