Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DTC IS CURRENT

Turn the ignition ON.
With the scan tool, erase Transmission DTCs.
Raise the vehicle on the hoist.
Start the engine.
With the scan tool, monitor the Input Speed Sensor RPM.
Firmly apply the brake pedal and place the gear selector in Drive.
WARNING:
To avoid personal injury or death, keep hands and feet clear of rotating wheels.
Release the brakes and raise the engine RPM to allow the transmission to perform a 2-3 and 3-4 upshift.
Did the Input Speed Sensor display an RPM above 7, 700?

Yes
- Remove the Transmission Oil Pan and inspect for excessive debris such as clutch friction material or metal contamination.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
No
- Replace and program the TCMA in accordance to the Service Information. Refer to VALVE BODY, REMOVAL .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .