LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 601 (3.0L Diesel - DTCS P05EF-00 To P2002-00 - 1500) >> Diagnosis And Testing >> P064D-00-Internal Control Module 02 Sensors Processor Performance - Bank 1 >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. ACTIVE DTC 
    NOTE:

    If there are any other O2 Sensor DTCs present, perform the Diagnostics for those DTCs before continuing with this one.

    1. Turn the ignition on.
    2. With the scan tool, record all Freeze frame data.
    3. With the scan tool, erase DTCs.
    4. Turn the ignition off for 75 seconds.
    5. Turn the ignition on, run the engine to operating temperature
    6. With the scan tool, read DTCs.

      Did the DTC reset?

      Yes 

      • Go To  2

      No 

      • Perform to the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT DTC .
  2. O2 SENSOR 
    1. Turn the ignition off.
    2. Replace the O2 Sensor in accordance with the service information.
    3. Turn the ignition on.
    4. With the scan tool, erase PCM DTCs.
    5. Start the engine and run it until it reaches operating temperature.
    6. Test drive the vehicle under normal operating conditions.
    7. With the scan tool, read PCM DTCs.

      Does the scan tool display this DTC?

      Yes 

      • Replace the Powertrain Control Module in accordance with the service information. Refer to REMOVAL .
      • Perform the PCM VERIFICATION TEST. Refer to PCM VERIFICATION TEST .

      No 

scientia non olet · About LEMON Manuals