Diagnostic Test

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
NOTE:
If there any CAN Bus DTCs present, perform the Diagnostics for those DTCs before continuing with this one.
1. Turn the ignition on.
2. With the scan tool, record all Freeze frame data.
3. With the scan tool, erase DTCs.
4. Turn the ignition off for 75 seconds.
5. Turn the ignition on, start the engine.
6. Test drive the vehicle under normal conditions.
7. With the scan tool, read DTCs.
  Did the DTC reset?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
ABS DIAGNOSTICS
Are there any ABS DTCs related to the Brake Boost Sensor present?

Yes
- Perform the appropriate diagnostic procedure. Refer to the DTC INDEX - 1500 .
No
- Perform the ABS VERIFICATION TEST diagnostic procedure. Refer to STANDARD PROCEDURE .