LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Occupant Restraint Controller (Orc) - Electrical Diagnostics) >> Diagnosis and Testing >> B223B-00-Vehicle Configuration Mismatch - >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. VERIFY ACTIVE ORC DTC 
    NOTE:

    Ensure the battery is fully charged.

    1. Turn the ignition on.
    2. Wait 12 seconds, with the scan tool, read all ORC DTCs.

      Does the scan tool display active B223B-00-VEHICLE CONFIGURATION MISMATCH - DTC?

      Yes 

      • Go To  2.

      No 

  2. VERIFY ORC PART NUMBER 
    1. With the scan tool, read the ORC part number.

      Is the part number correct for the vehicle?

      Yes 

      • Go To  3.

      No 

        WARNING:

        Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      • WARNING:

        If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with Service Information.
      • Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to Standard Procedure .
  3. CHECK THE TIPM CONFIGURATION 
    1. With the scan tool, check for Side Airbags and PAD Switch configuration.

      Does the Vehicle Configuration in the TIPM match the Vehicle Configuration in the ORC?

      Yes 

        WARNING:

        Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      • WARNING:

        If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with Service Information.
      • Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to Standard Procedure .

      No 

      • With the scan tool enter program network configuration and program the TIPM to the vehicle configuration.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
scientia non olet · About LEMON Manuals