Diagnostic Test
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE OCCUPANT RESTRAINT CONTROLLER (ORC)
- Turn the ignition on.
- With the scan tool, read ORC DTCs.
Does the scan tool display active B222A-00-VEHICLE LINE MISMATCH - DTC?
Yes
- Replace the Occupant Restraint Controller (ORC) in accordance with the Service Information.
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to Standard Procedure .
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
No
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to Standard Procedure .