LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Occupant Restraint Controller (Orc) - Electrical Diagnostics) >> Diagnosis and Testing >> B1BA5-00-Airbag Squib Configuration Mismatch - >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. VERIFY ACTIVE DTC 
    NOTE:

    Ensure the battery is fully charged.

    1. Turn the ignition on.
    2. With the scan tool, read ORC DTCs.

      Does the scan tool display active B1BA5-00-AIRBAG SQUIB CONFIGURATION MISMATCH - DTC?

      Yes 

      • Go To  2.

      No 

  2. VERIFY ORC PART NUMBER 
    1. With the scan tool, read the ORC part number.

      Is the part number correct for the vehicle?

      Yes 

      • Go To  3.

      No 

        WARNING:

        Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      • WARNING:

        If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with Service Information.
      • Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to Standard Procedure .
  3. CHECK THE VIN WITH THE SCAN TOOL 
    1. With the scan tool, read the VIN.
    2. Compare the vehicle VIN to the ORC VIN.

      Is the correct VIN displayed?

      Yes 

      • Go To  4.

      No 

      • Replace the PCM in accordance with Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  4. VERIFY TIPM CONFIGURATION 
    1. With the scan tool, read the TIPM configuration.

      Does the TIPM configuration match the vehicle equipment?

      Yes 

        WARNING:

        Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      • WARNING:

        If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with Service Information.
      • Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to Standard Procedure .

      No 

      • Re-configure or replace the TIPM in accordance with Service Information.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
scientia non olet · About LEMON Manuals