Diagnostic Test
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY ACTIVE DTC
- Turn the ignition on.
- With the scan tool, read ORC DTCs.
Does the scan tool display an active B0092-49-LEFT SIDE ACCELERATION SENSOR 2 - INTERNAL ELECTRONIC FAILURE DTC or shows a setting history in stored?
Yes
- Replace the Left Side Impact Sensor 2 in accordance with the Service Information. Refer to SENSOR, Impact , Removal .
- Perform the RESTRAINT SYSTEM VERIFICATION TEST. Refer to Standard Procedure .
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
No (Did not set a active or stored DTC B0092-49- LEFT SIDE SATELLITE SENSOR 2- INTERNAL ELECTRONIC FAILURE)
- Perform the RESTRAINT SYSTEM INTERMITTENT TEST. Refer to Standard Procedure .
NOTE:
If the scan tool shows this DTC has a Stored history of setting then the left side impact sensor is to be replaced.
NOTE:
Make sure the battery is fully charged.