LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Starting (Service Information) 1500) >> Starter >> Installation >> 3.6L

Section 565 (Starting (Service Information) 1500): Starter: Installation: 3.6L

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Starter
GC0154351Courtesy of CHRYSLER GROUP, LLC
  1. Position starter motor (3) to transmission. Tighten the bolts (4) to 54 N.m (40 ft. lbs.).
  2. Connect solenoid wire (1) to starter motor.
  3. Install battery cable eyelet (2) onto the starter post. Tighten the nut to 14 N.m (10 ft. lbs.).
    Fig 2: Remove/Install Components
    GC0154630Courtesy of CHRYSLER GROUP, LLC
  4. Install the heat shield. Tighten the nut (4) to 6 N.m (53 in. lbs.).
  5. Lower vehicle.
  6. Connect negative battery cable.
scientia non olet · About LEMON Manuals