LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 564 (Charging (Service Information) 1500) >> Generator >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL and SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
  4. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
    Fig 1: Nut, Ground Cable, Field Generator Connector, Protective Cover, B+ Cable & B+ Nut
    GC0153866Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the field generator connector (4).
  6. Remove the protective cover (1) from the B+ cable (6).
  7. Remove the B+ nut (5) and cable (6) from the generator.
    Fig 2: Nut & Ground Wire
    GC0158096Courtesy of CHRYSLER GROUP, LLC
  8. Remove the nut (1) and the ground cable (2) from the generator.
    Fig 3: Lower Outer Generator Bolt & Lower Inner Bolt
    GC0158179Courtesy of CHRYSLER GROUP, LLC
  9. Loosen the lower outer generator bolt (2).
  10. Remove the lower inner bolt (1) from generator.
    Fig 4: Transmission Cooler Hose Support Bracket & Nut
    GC0158075Courtesy of CHRYSLER GROUP, LLC
  11. Remove nut (1) and the coolant support hose bracket (2).
    Fig 5: Upper Generator Bolts & Generator
    GC0158068Courtesy of CHRYSLER GROUP, LLC
  12. Remove upper generator bolts (1) and the generator (2).
scientia non olet · About LEMON Manuals