LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Lamps/Lighting - Exterior (Service Information) - 1500) >> Smart Beam >> Standard Procedure >> Smart Beam Calibration >> Set Up Aim Board And Tripod

Set Up Aim Board And Tripod

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Set Up Aim Board & Tripod
GC0118501Courtesy of CHRYSLER GROUP, LLC
NOTE:

WK shown in illustration above. D trucks are similar. 

  1. Position the vehicle on a level surface in a dimly lit area.
  2. Place the aim board and tripod (4) (special tool #9649A, Alignment Device, Smart Beam) 1, 342mm (52.8 inches) ahead of the foremost center of the hood (2).
  3. Position center LED on the aim board at 694.5mm (27.3 inches) above headlight aim circle.
scientia non olet · About LEMON Manuals