Sensor, Stop Lamp: Removal: Removal
WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Using a trim stick (special tool #C-4755, Trim Stick) or equivalent, disengage the retainer clip that secures the hood release to the steering column opening cover, and remove the hood release handle from the cover.
- Remove the two fasteners (2) that secure the bottom of the steering column opening cover (1) to the instrument panel.
- Using a trim stick (special tool #C-4755, Trim Stick) or equivalent, release the retainer clips that secure the steering column opening cover (1) to the instrument panel and remove the cover.
- Locate the brake pedal position sensor (3) on the brake pedal support bracket under the instrument panel to the right of the steering column shaft (1).
- Disconnect the body wire harness connector (2) from the sensor.
- Depress both tabs on the sensor to disengage the sensor from its socket bracket (4).
- Pull the sensor straight rearward from the pedal support bracket to remove it from the sensor bracket.