LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (ORION - 68RFE Automatic Transmission (Service Information)) >> Fluid >> Standard Procedure >> Transmission Fill

Transmission Fill

WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:

  1. Remove dipstick and insert clean funnel in transmission fill tube.
  2. Add following initial quantity of Mopar® ATF +4 to transmission:
    1. If only fluid and filter were changed, add 10 pints (5 quarts)  of ATF +4 to transmission.
    2. If transmission was completely overhauled and the torque converter was replaced or drained, add 24 pints (12 quarts)  of ATF +4 to transmission.
  3. Check the transmission fluid and adjust as required. Refer to FLUID AND FILTER REPLACEMENT  .
scientia non olet · About LEMON Manuals