Throttle Body: Removal: 3.7L
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Using a diagnostic scan tool, record any previous DTC's (Diagnostic Trouble Codes).
CAUTION:
Never have the ignition key in the ON position when checking the throttle body shaft for a binding condition. This may set DTC's.
A (factory adjusted) set screw is used to mechanically limit the position of the throttle body throttle plate. Never attempt to adjust the engine idle speed using this screw. All idle speed functions are controlled by the Powertrain Control Module (PCM).
- Disconnect and isolate negative battery cable at battery.
- Remove air intake tube at throttle body flange (1).
- Disconnect throttle body electrical connector (3).
- Disconnect necessary vacuum lines at throttle body.
- Remove four throttle body mounting bolts (2).
- Remove throttle body from intake manifold.
- Check condition of old throttle body-to-intake manifold o-ring.