SENSOR, Manifold Air Pressure (MAP): Installation: 5.7L

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: MAP Sensor - 5.7L

Courtesy of CHRYSLER LLC

1 - MAP SENSOR

2 - FRONT OF INTAKE MANIFOLD

The Manifold Absolute Pressure (MAP) sensor (1) is mounted to the front of the intake manifold air plenum box. Refer to Fig 1.

Clean MAP sensor mounting hole at intake manifold.
Check MAP sensor O-ring seal for cuts or tears.
Position sensor into manifold.
Rotate sensor 1/4 turn clockwise for installation.
Connect electrical connector.