SENSOR, Air Temperature, Intake: Installation: 5.7L

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IAT Sensor - 5.7L

Courtesy of CHRYSLER LLC

1 - FRONT OF INTAKE MANIFOLD PLENUM

2 - IAT SENSOR

3 - RELEASE TAB

The intake manifold air temperature (IAT) sensor (2) is installed into the front of the intake manifold air box plenum. Refer to Fig 1.

Check condition of sensor O-ring.
Clean sensor mounting hole in intake manifold.
Position sensor into intake manifold and rotate clockwise until past release tab.
Install electrical connector.