INJECTOR(S), Fuel: Installation: 5.7L

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Injector Retaining Clip

Courtesy of CHRYSLER LLC

1 - PLIERS

2 - INJECTOR CLIP

3 - FUEL INJECTOR - TYPICAL

4 - FUEL RAIL - TYPICAL

NOTE:

If the same fuel injector is to be reinstalled, install new O-rings.

NOTE:

Apply a small amount of clean engine oil to each injector O-ring. This will aid in the installation.

Install the fuel injector (3) into the fuel rail (4) using a side to side motion while pushing injector into the fuel rail assembly.
Using suitable pliers (1), install the fuel injector retaining clip (2).
Install the fuel rail assembly. Refer to RAIL, Fuel , Installation for diesel, or RAIL, Fuel , Installation for gas.
Start the engine and check for fuel leaks.