Exhaust Temperature Sensor 1/1

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Oxygen Sensor Wire Harness Connector

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Disconnect the oxygen sensor wire harness connector (1).
Disconnect the upstream exhaust temperature sensor wire harness connector (2).

Fig 2: Nuts & V-Band Clamp
Courtesy of CHRYSLER GROUP, LLC
Loosen Diesel Particulate Filter (DPF) V-band clamp (2).
Remove nuts (1) and (DPF) inlet elbow from turbocharger.

Fig 3: Exhaust Manifold, Gaskets, Turbocharger, Cylinder Head & Fasteners
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.
Remove the exhaust temperature sensor (7).