LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 536 (Engine Cooling System - 1500) >> Standard Procedure >> Standard Procedure - Filling - 3.6L >> Cooling System Filling - 3.6L

Cooling System Filling - 3.6L

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

If vehicle has been run recently, wait 15 minutes before removing pressure cap. Place a shop towel over the cap, and without pushing down, rotate it counterclockwise to the first stop. Allow fluids to escape through the overflow tube. When the system stops pushing coolant and steam into the coolant recovery container and pressure drops, push down on the cap and remove it completely. Squeezing the radiator inlet hose with a shop towel (to check pressure) before and after turning to the first stop is recommended.

Fig 1: Locating Funnel, Locking Ring, Fitting Extension & Stopper
GC0144008Courtesy of CHRYSLER GROUP, LLC
  1. Install coolant fill funnel (1) (special tool #8195A, Funnel).
  2. Remove the upper heater core hose at the heater core.
  3. Fill the radiator to the recommended level.
  4. Install the heater core hose when coolant is present.
  5. Fill the coolant over flow bottle to the recommended level.
  6. Remove the funnel from the radiator.
  7. Install the radiator cap.
    Fig 2: Manual Single Zone Controls
    GC0089519Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The blower motor speed and the HVAC control positioning will determine the flow of coolant through cooling system.

  8. Start the engine and place the HVAC control (3) to full hot  .
  9. Place the blower switch (2) to low  .
  10. Allow the engine to warm up at idle for roughly 10 minutes.
  11. Top the coolant off if required.
  12. Increase the engine speed to 4, 000 RPM until the thermostat opens at 105° C (220° F) and verify the fan is operating.
  13. Shut the engine off.
    NOTE:

    The use of a external fan can be used to help aid in the cooling of the engine.

  14. Allow the engine to cool down enough for the thermostat to close.
  15. Top the coolant over flow bottle off if required.
  16. Restart the engine and increase the engine speed up to 4, 000 RPM until the thermostat opens.
  17. Allow the engine to idle after the thermostat opens.
  18. Verify the cooling fan is operational.
  19. Check the level of the coolant.
  20. Top the coolant overflow bottle off if required.
  21. Take the vehicle for a test drive.
  22. Top the coolant overflow bottle off if required.
scientia non olet · About LEMON Manuals