Cover(S), Cylinder Head: Installation: Right

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.

CAUTION:

Do not allow other components including the wire harness to rest on or against the engine cylinder head cover. Prolonged contact with other objects may wear a hole in the cylinder head cover.

Fig 1: Cylinder Head & Cover

Courtesy of CHRYSLER GROUP, LLC

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.

Clean the cylinder head cover (1) and the sealing surface of the cylinder head (2). Inspect and replace gasket if necessary.
Install the cylinder head cover and hand start all fasteners.

Fig 2: Cylinder Head Cover Removal/Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC

Using the sequence shown in illustration, tighten the cylinder head cover bolts to the proper specification. Refer to TORQUE SPECIFICATIONS .

Fig 3: Removing/Installing Ignition Coil
Courtesy of CHRYSLER GROUP, LLC
Before installing the ignition coils, apply dielectric grease to the inside of the spark plug boots (1).
Install the ignition coils.

Fig 4: Ignition Coil Electrical Connectors, Harness & Bolts
Courtesy of CHRYSLER GROUP, LLC
Tighten the ignition coil retaining bolts (3) to the proper specification. Refer to SPECIFICATIONS .
Connect the fuel injector harness connectors.
Connect the ignition coil harness connectors (1).

Fig 5: Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (1).
Install the air cleaner body (4). Refer to BODY, AIR CLEANER, INSTALLATION, 5.7L .
Install the clean air duct (2).

Fig 6: Installing Battery Cables & Components
Courtesy of CHRYSLER GROUP, LLC
Connect the battery negative cables (10, 11). Tighten the nut (1) to the proper specification. Refer to SPECIFICATIONS .