LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (3.0L Diesel (Service Information) 1500) >> Cylinder Head >> Removal >> Right Cylinder Head

Right Cylinder Head

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
  2. Remove the glow plugs.
  3. Remove the right side intake and exhaust camshaft shafts. Refer to CAMSHAFT, ENGINE, REMOVAL .
  4. Remove the followers and tappets and note their original position.
  5. Remove the water pump housing assembly. Refer to PUMP, WATER, REMOVAL .
    Fig 1: Cylinder Head, Head Gasket, Engine Block & Bolts
    GC0146684Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Do Not store the cylinder head on the sealing surface.

  6. Remove bolts (1) and the cylinder head (2) from the engine block (5) and discard head bolts.
  7. Remove and the head gasket (3).
scientia non olet · About LEMON Manuals