Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

PROGRAM THE POWERTRAIN CONTROL MODULE
1. Verify the PCM is at the latest calibration (flash level).
  NOTE:
  An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.
  
  NOTE:
  Diagnose any other DTCs that may have set with the P060B.
2. Program the PCM in accordance with the service information. Refer to the appropriate Testing & Diagnostics article in Engine Performance and follow the PCM/ECM PROGRAMMING procedure .
3. Start the engine.
4. Allow the engine to reach normal operating temperature.
5. Operate the accelerator pedal. (do not exceed 3500 rpm)
6. With the scan tool, select View DTCs.
  Does this DTC reset by itself?
  
  Yes
  - Replace and reprogram the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test Complete.