Diagnostic Test
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- CHECKING THE TEMPERATURE SENSORS. NOTE:
Diagnose and repair any ambient air temperature (AAT), intake air temperature (IAT), or engine coolant temperature (ECT) sensor circuit or rationality DTCs before continuing with this test.
NOTE:Diagnose and repair any crankshaft (CKP) or camshaft (CMP) sensor circuit or rationality DTCs before continuing with this test.
NOTE:Diagnose and repair any communication DTCs before continuing with this test.
NOTE:Verify that the Pinion Factor has been programmed correctly into the PCM.
- Perform the diagnostic procedure for CHECKING THE TEMPERATURE SENSORS. Refer to DIAGNOSIS AND TESTING
.
Were any problems found?
Yes
- Repair as necessary.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Go To 2
- Perform the diagnostic procedure for CHECKING THE TEMPERATURE SENSORS. Refer to DIAGNOSIS AND TESTING
.
- CHECKING THE ENGINE COOLANT TEMPERATURE SENSOR OPERATION.
- Perform the diagnostic procedure for CHECKING THE ENGINE COOLANT TEMPERATURE SENSOR OPERATION. Refer to DIAGNOSIS AND TESTING
.
Were any problems found?
Yes
- Repair as necessary.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
- Perform the diagnostic procedure for CHECKING THE ENGINE COOLANT TEMPERATURE SENSOR OPERATION. Refer to DIAGNOSIS AND TESTING
.