Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC(S) PRESENT
1. Turn the ignition on.
2. With the scan tool, check for DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the A/C Heater Control in accordance with the service information.
  - Perform BODY VERIFICATION TEST - VER 1. Refer to STANDARD PROCEDURE .
  No
  - The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
  - Perform the BODY VERIFICATION TEST - VER 1. Refer to STANDARD PROCEDURE .