LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 491 (Occupant Restraint Controller (Orc) - DTCS B1C19 To U1415) >> Diagnosis And Testing >> B2207-Occupant Restraint Controller Internal 1 >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR SQUIB RELATED DTCS 
    1. Turn the ignition on.
    2. With the scan tool, read the Occupant Restraint Controller (ORC) DTCs.

      Is there any squib related DTCs present?

      Yes 

      • Diagnose specified squib DTCs according to procedure in service information before diagnosing this DTC.
      • Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.

      No 

      WARNING:

      Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      WARNING:

      If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with the Service Information.
      • Perform the OCCUPANT CLASSIFICATION MODULE SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .