Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THAT DTC B2201-CALIBRATION MISMATCH IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.
  NOTE:
  Ensure the battery is fully charged.
  
  Does the scan tool display active: B2201-CALIBRATION MISMATCH?
  
  Yes
  - Go To 2
  No
  - Test Complete.
REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING:
Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING:
If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

View repair.

Repair
- Replace the ORC in accordance with the service information.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .