Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THAT DTC B1BA5 AIRBAG SQUIB CONFIGURATION MISMATCH IS ACTIVE
NOTE:
Ensure the battery is fully charged.
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.
  Does the scan tool display active: B1BA5-AIRBAG SQUIB CONFIGURATION MISMATCH?
  
  Yes
  - Go To 2
  No
  - Go To 4
CHECK ORC PART NUMBER WITH SCAN TOOL
1. With the scan tool, select ECU View, select ORC, select ECU Details, and read the ORC part number.
  Is the part number correct for the vehicle?
  
  Yes
  - Go To 3
  No
  - Replace the ORC in accordance with Service Information.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK VIN WITH SCAN TOOL
1. With the scan tool, read the VIN.
  Is the correct VIN displayed?
  
  Yes
  - Replace the ORC in accordance with Service Information.
  - Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Powertrain Control Module (PCM) in accordance with Service Information.
  - Perform the POWERTRAIN CONTROL MODULE VERIFICATION TEST. Refer to the appropriate Testing & Diagnostics article in Engine Performance .
TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase all DTCs from all Airbag modules.
2. If any ACTIVE codes are present they must be resolved before diagnosing any stored codes.
  WARNING:
  Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
3. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
4. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
5. The following additional checks may assist you in identifying a possible intermittent problem.
6. Reconnect any disconnected components and harness connector.
  WARNING:
  Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
7. With the scan tool, monitor active codes as you work through the following steps.
  WARNING:
  Maintain a safe distance from all airbags while performing the following steps. Failure to follow these instructions may result in possible serious or fatal injury.
8. Wiggle the wiring harness and connectors of the related airbag circuit or component.
9. If codes are related to the Driver Airbag circuits, rotate the steering wheel from stop to stop.
10. If only stored codes return, continue the test until the problem area has been isolated.
11. In the previous steps you have attempted to recreate the conditions responsible for setting the active DTC in question.
  Does the scan tool display any ACTIVE DTCs?
  
  Yes
  - Perform the appropriate TDC. Refer to STANDARD PROCEDURE .
  No
  - No problem found at this time. Erase all codes before returning vehicle to customer.