LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 490 (Occupant Restraint Controller (Orc) - DTCS B1B00 To B1C18) >> Diagnosis And Testing >> B1B71-Up-Front Right Satellite Acceleration Sensor Internal >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
  1. DETERMINE ACTIVE OR STORED FAULT CODE 
    NOTE:

    If the scan tool shows this DTC has a Stored history of setting then the front right impact sensor is to be replaced.

    NOTE:

    Make sure the battery is fully charged.

    1. Turn the ignition on.

      Is the DTC: B1B71-UP-FRONT RIGHT SATELLITE ACCELERATION SENSOR INTERNAL active or shows a setting history in Stored?

      Yes 

      WARNING:

      Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      NOTE:

      Inspect the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.

      • Go To  2

      No (Did not set a active or stored DTC B1B71-UP-FRONT RIGHT SATELLITE ACCELERATION SENSOR INTERNAL). 

  2. VERIFY OPERATION OF THE FRONT RIGHT IMPACT SENSOR 
    WARNING:

    Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    1. Replace the Front Right Impact Sensor in accordance with Service Information.
    2. Reconnect the vehicle wire harness to the sensor.
    3. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.
      WARNING:

      Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    4. Use the scan tool and erase the stored codes in all airbag system modules.
    5. Turn the Ignition Off, and wait 15 seconds before turning the Ignition On.
    6. Wait one minute, and read active codes.

      Did the active DTC: B1B71-UP-FRONT RIGHT SATELLITE ACCELERATION SENSOR INTERNAL return?

      Yes 

      • Go To  3

      No 

      • Repair is complete.
      • Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  3. REPLACE THE OCCUPANT RESTRAINT CONTROLLER 
    WARNING:

    Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    WARNING:

    If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

    If all possible causes are done. View repair.

    Repair 

    • Replace the ORC in accordance with Service Information.
    • Perform the AIRBAG SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .