LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Message Center (Service Information)) >> Switch, EVIC Control >> Removal >> Removal >> Avenger

Switch, EVIC Control: Removal: Removal: Avenger

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel, Screw & Switch
GC0144511Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. From the back of the steering wheel (1), access and remove the screw (3) that secures the left spoke front bezel to the steering wheel.
  3. From the face of the steering wheel, pull the outboard side of the front spoke bezel up from the steering wheel far enough to disengage the lip on the inboard side of the bezel from under the edge of the driver airbag trim cover.
    Fig 2: Front Spoke Bezel, Three Screws & Mounting Adapter Plate
    GC0145079Courtesy of CHRYSLER GROUP, LLC
  4. Pull the front spoke bezel (2) away from the steering wheel far enough to access and disconnect the electrical connector from the receptacle (1).
  5. From the back of the bezel, remove the three screws (3) that secure the mounting adapter plate (4) to the bezel.
  6. Remove the mounting adapter plate and switch from the bezel.
scientia non olet · About LEMON Manuals