LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Message Center (Service Information)) >> Sensor, Ambient Temperature >> Removal >> Removal

Sensor, Ambient Temperature: Removal: Removal

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ambient Temperature Sensor & Front Bumper
GC0147244Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Raise and support the vehicle.
  3. Remove the front fascia lower close out panel from the vehicle. Refer to FASCIA, FRONT LOWER, CLOSEOUT, REMOVAL .
  4. Reach up between the lower edge of the front fascia and the front of the a/c condenser near the right end of the lower air intake opening to access the ambient temperature sensor (3) just below the front bumper (1).
  5. Disengage the Connector Position Assurance (CPA) lock of the wire harness connector (2) for the sensor and depress the connector latch tab.
  6. Pull the sensor straight out of the connector.
scientia non olet · About LEMON Manuals