Sensor, Crankshaft Position: Removal: 2.4L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Crankshaft Position Sensor is located at the rear of the cylinder block, near the transmission.

Fig 1: Electrical Connector To Crankshaft Position Sensor

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Raise and support the vehicle.

Fig 2: Crankshaft Position Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the heat shield retaining bolt.
Remove the heat shield.
Unlock and disconnect the electrical connector from the crankshaft position sensor.

Fig 3: View Of Crankshaft Position Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the crankshaft position sensor bolt.
Remove the sensor.