Injector(S), Fuel: Removal: 2.4L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Risk of injury to eyes and skin from contact with fuel. Wear protective clothing and eye protection. Risk of poisoning from inhaling and swallowing fuel. Pour fuel only into appropriately marked and approved containers. Failure to follow these instructions may result in possible serious or fatal injury.

Fig 1: Fuel Injector Electrical Connectors

Courtesy of CHRYSLER GROUP, LLC

Release the fuel pressure, refer to FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
Disconnect and isolate the negative battery cable.
Disconnect the electrical connectors from the fuel injectors.

Fig 2: Fuel Line At Rail
Courtesy of CHRYSLER GROUP, LLC
Fuel line connection at fuel rail.

Fig 3: Fuel Line Connection
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel line from the fuel rail.

Fig 4: Harness Clips
Courtesy of CHRYSLER GROUP, LLC
Remove the wire harness from the fuel rail mounting studs.

Fig 5: Injector Electrical Harness
Courtesy of CHRYSLER GROUP, LLC
Remove the two bolts from the fuel rail at the lower manifold.

Fig 6: Fuel Rail & Injectors
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel rail.

Fig 7: Fuel Injector On Rail
Courtesy of CHRYSLER GROUP, LLC
Remove the clip holding the fuel injector to the fuel rail.

Fig 8: Fuel Injector & Rail
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel injector clip and fuel injector from the fuel rail.