Injector(S), Fuel: Installation: 2.4L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Injector & Rail

Courtesy of CHRYSLER GROUP, LLC

Apply a light coating of clean engine oil to the upper O-ring.
Install the injector into the cup on the fuel rail.
Install the retaining clip.

Fig 2: Fuel Rail & Injectors
Courtesy of CHRYSLER GROUP, LLC
Apply a light coating of clean engine oil to the O-ring on the nozzle end of each injector.
Insert the fuel injector nozzles into openings in the lower intake manifold. Seat the injectors in place.

Fig 3: Injector Electrical Harness
Courtesy of CHRYSLER GROUP, LLC
Tighten the fuel rail mounting screws to 27 N.m (20 ft. lbs.).

Fig 4: Harness Clips
Courtesy of CHRYSLER GROUP, LLC
Install the wiring harness clips to the fuel rail mounting studs.

Fig 5: Fuel Injector Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
Connect the electrical connectors to the fuel injectors.

Fig 6: Fuel Line At Rail
Courtesy of CHRYSLER GROUP, LLC
Connect the fuel supply tube to the fuel rail.
Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
Use the scan tool to pressurize the fuel system. Check for leaks.