Switch, Ignition: Removal: Removal
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- To remove the ignition switch, follow the procedure to remove the Sentry Key Immobilizer (SKREEM) module. Refer to MODULE, SENTRY KEY IMMOBILIZER (SKREEM), REMOVAL .
- If required, remove the SKREEM module (3) from the ignition key cylinder (2).
- If required, remove the ignition switch (1) from the ignition key cylinder (2).