Sensor, Knock: Installation: 2.4L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Knock Sensor Location

Courtesy of CHRYSLER GROUP, LLC

The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold.

Fig 2: Knock Sensor

Courtesy of CHRYSLER GROUP, LLC

Connect the electrical connector to the knock sensor.
Install the knock sensor and tighten the knock sensor bolt to 22 N.m (195 in. lbs.). Over or under tightening effects knock sensor performance, possibly causing improper spark control.
Install the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).