LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Ignition System (Service Information)) >> Sensor, Camshaft Position >> Removal >> 2.4L Front

2.4L Front

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Cam Sensor
GC0082374Courtesy of CHRYSLER GROUP, LLC
  1. Remove the air cleaner to throttle body hose and disconnect the inlet air temperature sensor electrical connector.
  2. Disconnect and isolate the negative battery cable.
  3. Disconnect the electrical connector from the camshaft position sensor.
  4. Remove the camshaft position sensor mounting screws.
    Fig 2: Cam Sensor
    GC0082375Courtesy of CHRYSLER GROUP, LLC
  5. Remove the sensor.
scientia non olet · About LEMON Manuals