SHIFTER, Transmission: Installation: Shifter

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shift Cable Retainer

Courtesy of CHRYSLER LLC

Install the shift cable retainer (2).
Install the shifter cable end (1).
Install the shifter assembly.

Fig 2: Shifter Assembly & Fasteners
Courtesy of CHRYSLER LLC
Install the fasteners (1), and tighten to 7 N.m (65 in. lbs.).

Fig 3: Center Storage Tray Fasteners
Courtesy of CHRYSLER LLC
Install the fasteners (1), then install the rubber liners into the storage tray and cup holders.

Fig 4: Power Outlet & Shifter Harness Connectors
Courtesy of CHRYSLER LLC
Reconnect the power outlet harness connector (1) and the shifter harness connector (2).

Fig 5: Console Bezel
Courtesy of CHRYSLER LLC
Install the console bezel (1).

Fig 6: Console Bezel Fasteners
Courtesy of CHRYSLER LLC
Install the fasteners (1) at the front of the console bezel.

Fig 7: Console Bezel Rubber Insert
Courtesy of CHRYSLER LLC
Install the rubber insert (1).

Fig 8: Shifter Bezel Trim Ring
Courtesy of CHRYSLER LLC
Install the console bezel trim ring (1).
Verify correct shifter operation. The vehicle should only start in PARK or NEUTRAL.