Console PRNDL Bezel

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Console PRNDL Bezel Release Clips

Courtesy of CHRYSLER LLC

Install the console PRNDL bezel, and verify all clips (1) are engaged.

Fig 2: Shift Position Indicator Lamp Connector
Courtesy of CHRYSLER LLC
Install the lamp into the console PRNDL bezel, and turn the harness connector 1/4 turn clockwise to engage the tabs.

Fig 3: Shifter Knob Lower Trim Piece
Courtesy of CHRYSLER LLC
Install the lower trim piece (1) onto the shifter lever.
Install shifter knob.
Pull the lower trim piece (1) upward to engage it on the shifter knob.

Fig 4: Power Outlet & Shifter Harness Connectors
Courtesy of CHRYSLER LLC
Connect the power outlet harness connector (1) and the shifter harness connector (2).

Fig 5: Center Storage Tray Fasteners
Courtesy of CHRYSLER LLC
Install the fasteners (1), and the rubber liners from the center storage tray and cup holders.

Fig 6: Console Bezel
Courtesy of CHRYSLER LLC
Install the console bezel (1).

Fig 7: Console Bezel Fasteners
Courtesy of CHRYSLER LLC
Install the fasteners (1) at the front of the console bezel.

Fig 8: Console Bezel Rubber Insert
Courtesy of CHRYSLER LLC
Install the rubber insert (1).

Fig 9: Shifter Bezel Trim Ring
Courtesy of CHRYSLER LLC
Install the console bezel trim ring (1).