Spark Plug: Installation: 5.7L
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Never use a motorized wire wheel brush to clean spark plugs. Metallic deposits will remain on spark plug insulator and will cause plug misfire.
CAUTION:
Do not attempt to clean any of the spark plugs. Replace only.
- Check and adjust the spark plug gap with a gap gauging tool (1). Refer to Specifications .CAUTION:
Special care should be taken when installing spark plugs into the cylinder head spark plug wells. Be sure the plugs do not drop into the plug wells as electrodes can be damaged.
- Start the spark plug into the cylinder head by hand to avoid cross threading.NOTE:
Always tighten spark plugs to the specified torque. Certain engines use torque sensitive spark plugs. Over tightening can cause distortion resulting in a change in the spark plug gap, or a cracked porcelain insulator.
NOTE:Spark plugs have a torque critical tapered design. Do not exceed 20 N.m (15 ft. lbs.).
- Tighten the spark plugs to 18 N.m (13 ft. lbs.).
- To aid in coil installation, apply silicone based grease such as Mopar® Dielectric Grease into spark plug end of ignition coil rubber boots. Also apply this grease to the tops of spark plugs.
- Install the ignition coil(s) (1). Refer to COIL, Ignition , Installation .
- Install all necessary air filter tubing and air intake components to top of engine and to throttle body. Refer to BODY, Air Cleaner , Installation , 5.7L .